🔧 Enhance Engine Performance with MAHLE Original MIS16340 Engine Intake Manifold Gasket Set Review

I really like this gasket set. Both intake manifold gaskets are marked Made in USA. They look strikingly similar to those removed by the OEM. I don't understand why you want to spend more to get Felpro.

Yes it comes with knock sensor gaskets I haven't fitted it yet but the quality seems good I think they are updating the kit as it is coming with two knock sensors and some people complain about it, for this price can't complain, good price and good quality.

when buying these gaskets also knock sensors buy wiring harness for knock sensors camshaft sensor oil pressure sensor oil pressure sensor strainer bottom in knock sensor gasket block bottom the groove cover also keep a piece of foam from the front and back the plastic base of the air intake to allow airflow to get under the air intake, keeping it cool and the area dry.

Fitted 7/10/18 - Gasket Kit had everything to restore the entire intake system. Intake Manifold Gasket, Nipple Gasket, EGR Gaskets, Rocker Cover Gasket, Rocker Cover Bolt Bushings, Fuel Injector O-Rings. Everything was of very good quality. TIP: Do not apply grease to the valve cover gasket or it will not remain locked in the valve cover channel during assembly. I did this and had to clean the seal with a degreaser. After that everything is fine.

Excellent quality as expected, Victor Reinz seals are usually first class. I accidentally ordered this kit for a 4.8 and luckily the intake valve is identical for this engine. This kit includes new injector o-rings, rocker cover gaskets and a lower valley gasket that should be replaced while you're there. At $65 this is a steal compared to other kits available. The only snag is that it only comes with 8 of the 10 upper inlet screw seals. No problem as they don't get as hot as the intake…

This gasket kit contains the following: 8 Fuel Injector O-Rings (Intake) 8 Fuel Injector O-Rings (Outlet) 2 Intake Manifold Gaskets 1 Push Rod Cover Gasket 2 Rocker Cover Gaskets 8 Rocker Cover Gaskets 4 Waterway Gaskets I have these Used on my 2003 Hummer H2 when I replaced the knock sensors. The knock sensors are located on the underside of the engine, so the intake manifold must be removed to access the sensors. While I was there I just replaced all of those gaskets. This is necessary…

This kit had everything I needed. I prepared some pan gasket spacers as everyone was complaining that they weren't included in the kit. It turns out that it comes with 2 sockets. Revain needs to update this product's photo to show the included bushings. I replaced the injector o-rings after cleaning them. This whole work took me about 10 hours. I had to clean a lot. My valley pan gasket was bad and there was oil everywhere. The intake gaskets were also bad. I added RTV silicone to the sump seal

I recently got a knock sensor low voltage code P0332 in my 2006 Silverado which was entirely my fault due to an engine flush and water in the knock sensor well. In hindsight, I should have just bought the intake manifold gaskets, but I spent a few extra bucks on this kit instead of the Fel-Pro gaskets just in case I found out that additional gaskets were leaking. The intake manifold gaskets are plastic with rubber seals versus the metal Fel-Pro. Not sure if it's any better than the OEM, but my…