Metal Bike Motorcycle Mount Unbreakable Review

I chose this model over the RAM mount as there seems to be a surge in counterfeiting on RAM mount deals and it's $40 cheaper. The mounting part (which holds your phone) is plastic, for the price I think most of that has gone into the metal clip that attaches to the steering wheel. Ideally it should be metal too, but price wise I can see why it's not ideal. For a Note9 with a case, it's a little tight on the rubber grip that locks the corners. I'd say a smaller phone would probably suffice, but…

I think my scooter handlebar system is very strong, but. The part that holds the phone holder is a small piece of plastic that allows the phone to rotate (depending on how tight it is). If you have a strong metal frame holding the mount to the handlebars, but the most important part of the mount is plastic, it doesn't give much confidence in the mount. When I go over bumps, the holder moves more and more with each bump. Unfortunately, I have to stop to get back into the right position. After…

I switched from plastic to metal because I was replacing another similar plastic product that was left in the garage after a cold winter has fallen apart. Installation was easy, I had to use the largest loop to fit my handlebars. The knurled screw helps to tighten the clamp. The ball joint is plastic so I hope it doesn't fall apart after this winter. I rode 22 miles on tarmac and concrete with lots of bumps. The rubber strap didn't budge, nor did the clamp mount, but the ball socket slipped and

Updated 9/29/21. I give three stars but I cannot recommend this item. Of course, the screws for tightening the clamp that secures the entire unit to the steering wheel didn't work. Just managed not to lose my $1200 phone thanks to great reflexes. Look, it might be good if you use it on a bike but not a Harley. I would do this hard. Sorry I wanted to take a picture but you know what it looks like. To be honest, I resisted buying something like this for a long time. I didn't even think I wanted…

I just received the mount and will be keeping it for at least a week but am considering returning it due to construction work. As another reviewer said, the base is aluminum. This was important to me as my Arkon ball mount, which seemed to be made out of a pretty good material, broke after a couple of seasons of use after putting my helmet and jacket on it (not often and not much strain on the mount ). ). ). So the base is pretty good, but I would have preferred a Phillips head screw to attach…

Edit: Customer service was very responsive and processed my warranty by quickly replacing the product within 1 week of the initial email. I have many concerns about the internal design of the tensioner, but I'll try again. Too bad I can't get 3 1/2 stars. First Rating: The clip system for attaching the device to the handlebars is excellent, which is why I have upgraded my rating to two stars. Without the handlebar clamp that would be a solid star. The handlebar clamp does not scratch and is…

A little over a week has passed. I ride my bike (motorcycle) almost every day. I wanted to buy a butt grip but it was too much for me and I finally found this one. There wasn't room on the handlebars of my off-road bike, so I somehow wedged it into the base of the left rear-view mirror. Installation time less than 2 minutes. Performance - My off-road bike is designed for dual sport and has studded tires. Therefore, it vibrates even when I drive on a flat road. That was my BIGGEST concern…

I've been installing this product on my 2019 Harley Davidson Sport Glide for a few days now and have put over 3,200 miles on this product and I have to say this is the best phone mount you have in this one Price range you can buy. The pros and cons are listed below. Cons: 1. If you do not fully tighten the ball joint lock nut, the seat will loosen and easily disengage from the ball mount.2. Although I ordered a metal handlebar mount, the side of the socket that attaches your phone is entirely…