🔴 High-Quality MG21102 Red Dana Axle Tube Seal - Perfect fit for Jeep Cherokee, Wrangler, and Wrangler JK Front Axles (30/44) Review

Will not fit 2014 Jeep Wrangler Rubicon. The axle shafts rub against the seal. waste of money. The return window expired when I installed them.

Do this when replacing axle spiders or inner axle seals. Use some RTV or the right stuff. We'll see how long they last but they fit my 98 xj perfectly.

Install my yj dana30 tubes as others have said you can't get a grease gun on them with straight mirrors so I put 45° mirrors on them before installing attached also i have tj solid axle, they don't fit the cad axle, they have to make a set for this application

I love the design and look of the product, the problem is that it is too loose in the axle tube. It looks like it needs to be a bit thicker or have rubber o-rings to seal and hold it in place.

Really cool idea. I never thought of all the dirt stuffed into my trucks but it really adds up! While changing gear, I put them on because I was right there and they looked cool. I'm sure they will help in the long run. I've only ridden it a few times since installing them, but so far so good!

These axle seals appear to be quite well made. The finish is very nice and the oiler works well. However, the seal diameter at the end of my axle tube was hardly too small. This caused the seal to rotate along with the axle. I ended up wrapping the link with black silicon tape and it fit snugly into the axle tube which kept it from rotating. If the O.D. of the gasket was about 1/16" larger, it would fit perfectly.

Don't waste your money. You get the theory, but this product will have you tearing your hair out and throwing wrenches across the garage. After I installed them he went to oil them, you know what, you don't get a tip for a grease gun. After installation, the tip is too close to the axle housing. Luckily I was able to remove the mirror and use a grinder to make room. Not the end of the world, is it? Well, then these damn things didn't take fat. I guess I'll just let them burn and put on an…

Product looks good and is very easy to install. The only issue I have is that the grease fitting will not turn once it is fully inserted into the tube to fill with grease. There are two fixes for this; The first option is to not fully insert the pipe seal into the pipe just enough to run the grease gun around the nipple, the second is to purchase separate 45-90 degree grease fittings and install them before the Pipe seal is installed in the pipe pipe. Seal. I didn't know this before installing…