🔌 MICTUNING 12V Fuse Relay Switch Harness Set - 30A ATO ATC Blade Fuse, 5 Pin SPST Automotive Electrical Relays with Heavy Duty 14 Gauge Wires - Pack of 6 Review

I like that it's easily accessible to replace the fuse if needed. But I feel like the fuse is not that easy to protect as it can be bent and is already bent :-(. This really eliminates the need to use a line fuse with the battery wire +. leave the relay as a spare.

Ordered 3 sets, 15 pieces in total. 1 device (of 15) was defective. The fuse location is not the best for my application (fuses are easy to hit and bend) but the units are exactly as shown in the pictures. Just a warning, the fuse is fine as long as you install it somewhere safe. I've only tested them at 5A and replaced the included 30A fuses with 2.5A to 10A fuses, so I can't comment on full load capability. Vibrations and rough handling: no problem.

I used the product for power locks and trunk release when installing the remote start. The relay is rated for 30 amps, I can tell you there is no outlet, the wires are not 10 gauge as required for 30 amps. The wires on the outlets are also too short, only about 6 inches long, and the fuse is loose and tends to fall out without bouncing around much. The overall price is good, but if you're going to use it for high-current applications, I'd steer clear of it.

Let's start with one downside first, the harness is neither waterproof nor durable. However, it is well built in all other aspects; The connectors hold the relays securely in place, the blocks can be connected with padlocks, and the wiring appears to be long enough and of good quality and gauge to handle the expected loads. The relay is of excellent quality and the fuses are very tight. The mounting tabs are very secure in the relay and I had to work hard to remove them.

These relays have a great design idea with the fuse included. Simplify wiring and eliminate the need for a fuse box. I tried to find a waterproof device of the same design but had no luck unless someone was willing to spend big. the switch is off. After everything was dry, everything was fine. I tested another relay by pouring water on it and the same thing happened. So they are not intended for my application. I ended up filling the fuse cavity with electric grease and so far so good.

I installed several of these on my son's drive wheels. One is fed from a fuse box powered by two 12V 7Ah batteries and the other is built into the standard battery system. Both are tied to an aftermarket key that I installed. Works great after my son turned it on and off a million times for a week. Advantages; Easy to install, price, wire harness included, 5 pin relay, fast switching. minuses; It's a stretch but the fuses were slightly bent from the little book they were packaged in. Overall I…