🔧 Enhanced MICTUNING HD+ 12-Gauge LED Light Bar Wiring Harness Kit with 60Amp Relay, 3 Free Fuse, Blue Rocker Switch (2 Lead) Review

I had to wait to get my lightbar before writing a review. After determining where everything needs to be connected, the installation took less than an hour. All the equipment was there and it was very easy, just taking my time. Lots of cables for my setup. I only need one set of cables for my lightbar. The other set was sealed with tape. The same with the switch. I only connected 3 wires instead of all 5. I recommend it to anyone.

This would be a 5 star product if the manufacturer corrected the instructions (cable color codes off). I watched a video on You Tube where someone had already figured out the correct color codes, but otherwise I would have been stumped. They also do not provide instructions for attaching to the ignition source, so turning off the ignition will turn off the light. If you install according to the instructions, you must remember to turn off the light. You could just provide an Add-A-Fuse connector

This product works as intended but does not meet my needs as well as I had hoped. I used to manually wire my lightbar to 14AWG and didn't do a clean install, so I was hoping this would make an improvement. It improved the visuals somewhat, but I just didn't have enough time to not use my own wiring for something. I couldn't actually install the relay because the wiring to the switch is barely long enough. They say that the switch itself and the wiring are very high quality. Nothing will…

This wiring harness was easy to install and more than long enough for a side install. As has been said in previous reviews, everything is strangely connected. A power supply for relays and backlight. I'd like to see 4 wires per relay so you can activate the relay with switched power and then use full size wires for the lights. As for the backlight, I haven't connected the backlight power supply yet. I would suggest that when you cut the heat shrink from the relay there should be four wires but…

I have used these before on my 300 watt light bars and they do a great job providing enough power for my lights. I have bought 2 more to replace a pair of 14/sensor 16 rentals I currently have on the truck, will be doing so this week. Can't beat them for quality and value. I've now hooked up all my headlights to the BLAZER remote box, best $45 I've spent in a long time, it will contain EIGHT (8) different bulbs with relays built in, ranging from 1.5 amp (2), 5 amp (2), 10 amp (2) and 20 amp (2)

Better for light to moderate use than heavy use. The power/ground wires are too short. The cables that go into the passenger compartment to the switch on the dashboard can be slightly longer. Overall a good set of cables for some small LED lights. Edit #2 (see photo). So I connected the cable to the battery as indicated. My headlights work as does the switch, so no complaints about the features. But within two weeks I noticed that my car revs slowly when I start it. So I decided to put a…

Great product. The wiring harness to the wand and battery is 12 AWG wire and from the relay to the switch is 20 AWG wire, which is not a problem. The length was enough for all cables except those in the cabin. My battery is in the front corner of the engine bay on the driver's side. I had enough wire for the pole/battery. The switch wire would be long enough if you wanted to mount the switch low on the dash to the left of the steering wheel, but I added about 18 more inches of wire and placed…

With this product, I installed a 600W off-road LED panel on a protective grille. The wiring is capable of providing higher wattage lighting and the wire wrapping, connections and shrink tubing around the relay harness look professional. However, a major disadvantage of this design is that no pre-wiring has been done. a separate power supply for the switch itself. The power supply to the switch is spliced inside the heat shrink tubing on the relay harness from the main power supply, which must…