🔥 MMRAD-E36-92 Performance Aluminum Radiator for BMW E36 3-Series (1992-1999) by Mishimoto Review

This is my second Mishimoto radiator for my M3. After 3 years of intensive use, the pipe in the intake area began to leak. Guarantee could not be shown, no receipt. I thought this was a good suggestion but couldn't install the hoses, the overflow nipple is too close to the inlet. They advised bending it, but the top weld did not allow the clamp to sit normally and also broke. So they sent me another one. Good customer service and I hope that the new device has no problems.

Fits my E36, 1998 323is with M52 engine and AUTOMATIC transmission. The top hose and bleed fittings were fairly close together. I ended up tightening both by running them with the hose clamps and then sliding them all the way at the same time. That was my only problem. Everything else was 100% OEM ready. All aluminum. The cooling capacity is greater than stock. Imo worth the extra money because you get more. Highly recommended. I would buy more, but with a lifetime guarantee, there's no need.

The radiator has found its place in our '99 M3. Fits like a glove, easy to assemble - homemade. The month is installed and works without problems. The polished aluminum finish looks great in the car - the cooling performance is excellent. What to look out for: Inlet and outlet pipes are polished. The hoses fit almost too easily and require the hoses to be tighter than you think. - You will need 6mm screws to reattach the fan cover, the factory pins will not work. - If you have a factory…

M52 replaced by e30. I was skeptical about ordering from Amazon after reading reviews that the reservoir return hose didn't fit. I had zero problems. I saved a few bucks by ordering through Amazon and the product is as beautiful as I expected from Mishimoto. Cooling with this cooler goes beyond the MZ3 cooler with the replaced E30. I increased the clearance to the motor by an inch which reduced heat absorption etc since the three rows are so close to the motor. Sometimes less is more. I will…

A very solid radiator with a first class guarantee. The Mishimoto staff have truly outdone themselves when it comes to customer service. I bought this cooler to replace an original unit that was damaged by the previous owner of my car. Unfortunately, a few months later, I had an accident myself, which caused the new radiator to burst. Warranty Mishimoto will replace the unit at the specified shipping cost with proper damage documentation and a police or insurance report. <---KEEP ATTENTION…

Great heatsink. You can see a lot of feedback on the quality of the cooling and it's as good as everyone says it is. So I will check the e30 package. You may have heard it fits e30s and yes! Fits well for my later 325i. I bought it for my 1990 325i. Perfect for getting in the car. I had a little problem with the top two left tubes. As you can see from the photo it is a tight fit. I absolutely couldn't get my hoses out. I could put one hose on top or bottom, but there wasn't enough room for the…

Overall a good improvement on the stock plastic radiator. More expensive, but with a lifetime warranty and metal construction, it's a worthwhile upgrade over standard, failure-prone plastic. First problem - Not all of us have manual transmission cars - It has Auto Tansmission radiator brackets BUT they resized the brackets from the stock radiator - WHY! - and if you MUST do it, WHY didn't you provide 4 bolts - A small change but for the price they should be included - If you have a car - you…