🛥️ Moeller Marine Reed Switch Fuel Sending Unit: Complete with Gasket and Screws - Advanced Electrical Solution Review

I purchased this product to replace a faulty potentiometric gauge on my boat. Upon arrival I immediately noticed the reliability and quality of construction using stainless steel metal components to avoid possible corrosion from water in the fuel. Since there is no mechanical connection between the plastic float and the metal tube it runs through, not much can break either. It installs quickly and easily, replacing the previous sensor with no modification other than splicing the wires. The kit…

I didn't set it in the marine app so it's a strange setup. I put it in the mower. Due to installation design limitations (1 inch clearance below the bottom of the sensor) and about two inches of EPA airspace at the top of the tank, my setup points about 1/4 of the tank down. the part works very well (and my setup on a plastic tank works very well with lightly tightened sheet metal screws, but I bet that's not recommended). Sloshing in the tank makes my sensor wobble a lot. I assume that the use

Used to replace the fuel tank sender assembly with a long wire arm with a small float that stops reading the fuel level once it falls below halfway. It's much easier to install and place right in my aquarium. I just measured the depth of the tank and ordered a block an inch shorter. This transmitter block is made from high quality stainless steel and should last a while. It comes with two sets of 6 screws, one of which fits directly into the screw holes in the tank. It also comes with a rubber…