Renewed NETGEAR PowerLINE WiFi 1000 Mbps with 802.11ac and 1 Gigabit Port - Essentials Edition Review

We used it to remotely access a wireless Nest camera that was out of range of a wireless router. Most "wireless" extenders need to connect to a subscriber-supplied router (such as AT&T, Spectrum, etc.) via WiFi. This one works differently. You connect it (with an RJ45 cable) to the subscriber's router so that "it doesn't use the subscriber's Wi-Fi" to connect to the subscriber's router. We've had a lot of issues in the past using the subscriber's Souter WiFi to connect extenders (most setup…

Very cool. I installed this in the house and it worked great in the house. I took the block to the garage and nothing. so i discovered at least two things: if both the base and end units are connected to the power supply on the same side of the switch box, that's great. If the base is powered on one side of the panel and the termination unit is on the other side, it will not work. They are ideal for a large house, second or third floor, etc. If your garage has mains electricity on the other…

As in many homes, wired/Internet access is in the same room. This is usually a shared space (living room or study), which means that if you want to get a signal somewhere else, you'll have to pay for a second dial-up connection in another room, or run ethernet through the walls where you need it . For reference, my main connection is in the common room. open concept with kitchen and my office on the other side of the kitchen wall (same floor). Wi-Fi didn't help, especially with the number of…

short version: IT WORKS! Longer Version: I needed to extend wireless access to an outbuilding on my property. After a little research I've come to the conclusion that I have two options, both of which are quite expensive: I can run a separate maintenance line into the building and pay a monthly maintenance fee. or I could run a wireless bridge between buildings. At around $500 a wireless bridge would cost more, but after a year or so it would be a better deal with no ongoing fees. But then I…

I have 2 of these now. 1 in a mast shed over 150 feet from the router and 1 in a garage about 50 feet from the router. Both register the same speed as with a direct connection to the router (for me it's about 19/2 Mbit/s with a landline provider). I understand why people take a point off because you have to use a different SSID for each one and manually switch your device, but that doesn't bother me in the least. Now I can still stream my AT&T TV (3 streams) and run security cameras (10+)…

Internet connection to the back of our house where our bedroom was located could not be established. where can we get a modem The Wi-Fi extenders either didn't connect well to the modem or we moved them closer to the modem. Again we didn't have a good signal in the back bedrooms. That. These things are so easy to set up. and when i had connected everything, i picked up the receiver. pocketed it in the hallway by the bedrooms. and everything is good. in the same room, one in one outlet, one in…

I have to admit that I really don't understand or know why this NETGEAR PowerLine 1000 isn't working for me, but it just isn't working. It was installed correctly and plugged directly into the outlets. I compared several PCs and PCs in different places in the house and found that the minimum DOWN/UP loads are the same in both cases. However, from my laptop BOOT is 50% faster than when this system is enabled with direct connected or Wi-Fi versions. That doesn't mean it doesn't work for you guys…