Efficient Nilight 2PCS Square LED Trailer Light Kit: Submersible, Low Profile, IP68, Stop Turn Tail Marker License Light for 12V Utility Trailer Boat Camper RV Trucks Marine Snowmobile + 2 Years Warranty Review

The 4 pin connector to the car didn't work! I had to take it to the store to check the connection as the instructions say, but the light didn't work. It took two hours, they said I had it set up really well, they found that the 4 pin connector on the new cable that goes into the car didn't work after taking everything apart and they took the old one cable I had a magnetic kit I had. and spiced it up for me and now the light works but now all the wires are hanging down and it looks really bad…

The light is a typical trailer light housing. The case is NOT sealed so water can get inside the case, but the circuit boards containing the LEDs and connectors are sealed so they should withstand water immersion with ease. The screws that come out the back of the lights are NOT stainless steel (although they advertised stainless steel fasteners), WILL rust and CANNOT be replaced. It also comes with crimp connectors which are also NOT marine grade and will fail over time due to corrosion. I…

The first red flag is the flyer on the top that promises a free gift if positive feedback is left. Second, how badly this kit is made. I immediately noticed thin wire and cheap fittings. First I added reflectors. To a brand new and freshly cleaned stainless steel trailer. Then I wanted to mount the side marker. I carefully drilled a 1/64" hole and began installing one of the included screws. It broke before there was an impact, plugging the hole. I decided to go back there and put the tail…

1. Tail and side lights use a separate ground wire instead of relying on the ground path created by bolting or bolting the light assemblies to the trailer's metal frame. The ring terminals provided for grounding are tiny, not as shown in the product photo. The easiest way to ground your taillights is to purchase a larger spade, cut the excess ground wire, crimp or solder the wire to the spade, and tighten the spade under one of the two rear studs. I had to enlarge the hole in the ring a bit to…

When I received this set I was pleasantly surprised with everything that was in it. I wasn't expecting the kit to come with a full wiring harness and connectors so that was a plus. Everything was easy enough to hook up, although I wish the instructions were a little clearer on some of the components. There is some kind of sticky pad on the taillights but it's not clear where they go so I just put them on the "bright" side without any glue. I ended up using my trailer's existing wiring, but I'm…