🚗 Enhance Automotive Diagnostics with OBD Detector Breakout Box for CAN Data Line Signal Analysis Review

After reading other reviews. I checked the wiring and everything was fine. As well as testing, I had to apply 12v to the connector as the car had an underlying electrical issue. Worked great.

Warning! This BOB does not work as advertised. I can't read pins 6 and 14. I hope this saves someone from making the same mistake I did.

Received my box in no time. I've used it twice so far and I'm very happy with it. The lights all work and there are no problems with the contacts, everything works fine, the test can be set up. I'll be using it on a Dodge Dakota truck over the next day or two to find a big bus that won't be a problem. I'm sure it will do the trick. I would recommend it to anyone looking to buy a breakout box.

When I bought this OBD Break Out Box, I liked that all 16 pins are in the same pattern as the connector on the car. I wasn't looking for anything unusual and didn't need an expensive one. I just needed easy access to test CAN BUS. Well on my first car with a CAN BUS problem I connected the BOB and found an open circuit between pins 6 and 14. I unplugged the BOB and I had 120 ohms at the OBD connector on the car between pins 6 and 14. Then I checked the resistance between the wires on the…

I was skeptical after reading some of the reviews but I also noticed that some were expecting something other than a simple junction box. The first thing I did was make sure all the pins and ports matched and connected. The only thing that seemed a little strange is that when I checked the two sites, I found that there was little continuity between them. When measuring the chassis ground between the pin and connector, there was continuity and no resistance. When checking another signal ground…