💪 Improved Packard C140A Pole Contactor Coil for Enhanced Performance and Efficiency Review

This contactor worked perfectly on my Lennox XC14 series 5 ton capacitor. The only difference was that my original contactor had screw terminals on the top/output side while this one had screw terminals. It was easy enough to cut off the ring connectors and insert the bare wire into the provided screw terminals. Replacing it was great preventative maintenance as my 7-8 year old contactor was badly scratched and will likely fail in the near future. Much better to spend about $11 here and do it…

Working great after 2 full AC seasons in the mid atlantic state. I'm not an HVAC technician but an educated homeowner. Just make sure it can handle a 24 volt control circuit and is rated at least 30 amps at 230 volts. It's 40 amps the better. My original contactor on my 20 year old Ruud condenser looked burned around the edges of the dots AND the compressor knocked once or twice at start causing the lights in the house to flicker. When I bought this contactor it was only $6 and I couldn't…

The relay has nothing to rate or rate. It either works or it doesn't, which is why I haven't done it yet. Got this to replace the relay that controls the external A/C compressor and fan after the old one died. It worked great for a little over a year, but last night I walked by the window and noticed the outdoor unit was working. Even after completely shutting down the entire internal system, it still worked. It went away on its own after a while before I could start diagnosing it, but I think…