PAGOW Self-Adhesive Printer Insulation Sticker Review

You really need to remove the piece for the temp sensor (otherwise it will falsely tell you your pump plate is hot enough when it isn't and you must Remove the parts for bed clips, I have new ones, they seem good, but original clips are best (or binder clips I think, but I haven't tried).

I got this to insulate my Anet A8 Plus heatbed and it worked like a charm. Went from no more than 85°C on a PETG bed to 100°C. Thankfully, since the foam was exactly the same size as a standard bed, no trimming was required. My only thought is that I would like the foam to be denser, but that's about it. Let's see how it behaves over time. I will update my review in a few months.

Some things you should know. 1) It may not cause your bed to heat up faster. 2) It will not be a pre-cut whole for the screw and springs for your bed. 3 ) It's complex, so apply it to something for a few days before using it, otherwise you will have a little trouble applying it. So why did I buy something like this? Well it keeps the heated bed holding its temperature and boy does it do a good job. Also, the printer uses less power to keep the work surface hot. Not much, but there is, and if…