🔧 Performance Tool 0-200 Accessory - Model W10055 Review

Mine came with a metal handle as described on the site. I was concerned as some reviews said they have plastic handles that will crack and break. So I wanted a better METAL joystick. This is an exact valve/manifold replacement on my tractor air intake tank. It took about 10 minutes to remove and replace the old one. It sat in the garage at 125 pounds for about 6 hours and didn't lose any noticeable air pressure. Also great, it arrived VERY quickly. Ordered Friday afternoon, arrived in the mail…

I bought this primarily as extra air storage for my 25 gallon compressor. So I look at the tank itself first, which is pretty good. The manifold, hose and air cartridge included in the kit are not suitable as they restrict flow. By adding a tee in place of the manifold, you can fit a pressure gauge on one end and a quick-release chuck on the other. This allows you to fill the tank in 12 seconds instead of 2-3 minutes with a tire valve on the manifold. It can be safely inflated to a pressure of…

in a sealed air reservoir for my air suspension so I have enough air instantly to bleed my front forks and rear shocks when needed. So I needed a 1/8" male NPT Schrader valve to thread into the 1/8" plugs I had welded to the swingarm so I could check for leaks after the welding was complete . fill my pendulum with 120psi air and check for leaks. So I paid almost $6 for this little brass valve. (Really a piece of crap) The threads on this valve fitting are absolutely horrible and will not thread

I was a little concerned with other reviewers who said the open/close handle immediately came loose and stopped working. When mine arrived I tested it and it worked fine. I noticed that this manifold isn't as thick walled as the one I replaced, but I think it's probably just a more efficient design. I saved the hose and gauge from the old manifold. After installing the new manifold on my portable air tank, I filled it up and checked for leaks. Then I connected the hose and when I started…

The PSI dial is a little hard to read but lightweight and easy to carry and store. Filling was easier than other tanks I've used in the past. UPDATE September 30th 2021 - The filled tank to 100psi came back after a few hours and the fuel gauge showed 0psi - obvious leak source (no noise or other cause found) I will try to find the source of the leak with soapy water etc today I have contacted the seller and am waiting for a response from him. will be updated as new information becomes…

I was wary of buying this air tank manifold because of all the negative reviews from people who bought a cheap plastic handle it was what it was on my air tank that needed replacing. However, I ordered mine from Revain as a retailer, not an independent retailer, assuming I would get the latest version with the metal handle. At Revain, the supply is always replenished and mostly fresh. If an independent seller is listed on Revain, their stock could sit on the shelves for years. My hunch was…