PowerDrive 7473 Kevlar Replacement Aramid Review

The belt was too short for the application, it should fit, Couldn't adjust enough for the belt to work, had to buy the original belt

So far so good, the belt seemed to be of good quality and works great, it fits my 310-8 wheelhorse perfectly and seems to have a lot more strength, also now the clutch works as it should.

. The belt is advertised as a replacement for the Toro 7473 belt. This belt says it's an 82 inch belt but it's not. It is about 2 cm shorter. I'm sending the strap back in the hope that the one that was delivered is actually the right length, but for now I see this as false advertising.

This belt just didn't work. Firmly adjusted and the clutch would not let go. This is the correct part number for my 1988 312-8 wheel horse. Torn apart in less than five minutes trying to disengage the clutch. Very disappointed, I have to rip this thing apart again.

is advertised as a replacement for the Toro 7473 belt. The length of the Toro 7473 belt must be 82 inches. This belt says it's an 82 inch belt but it's not. It is about 2 cm shorter. I'm sending the strap back in the hope that the one that was delivered is actually the right length, but for now I see this as false advertising.

I have a Wheelhorse 1982 GT-1848 workhorse. The strap fits snugly, but after about half an hour the cord/fabric used for the outside of the strap broke. I need to scrape the fabric off the spindles and cut the cord where it came out of the belt. After it's cut I use a lighter to melt a piece of string to glue it back to the belt. After that, the belt works as expected. I have bought 2-3 belts from this company and they all do the same thing. I learned very well how to remove sidebar to solve…