Premium Mud Flaps Splash Guards for Tesla Model Y 2020 2021 - Set of 4 (Front and Rear) Review

There aren't any videos on YouTube on how to fit fenders on the Model S, but there are some on how to fit the Model 3. Also here on Revain there it There are plenty of fenders for the Model 3, but not so much for a Model S. Also, I've driven quite a bit and have never seen a Model S with fenders, so my conclusion is that the Model S just wasn't designed for fenders. I was barely able to mount the front fenders, thinking I should have drilled a hole in the metal for the top screw, but instead I…

Installation is easier than it might seem at first glance BUT WHY NO INSTRUCTIONS - in the box or on the website. One star less. The little in Revain's product description is misleading. I spent a lot of time figuring out what to do, including buying shims that turned out to be unnecessary. DO NOT DRILL HOLES. Believe me. Just remember to lean the fender against the wheel arch and then insert the rivets. If you put an inside rivet under the fender and then put a rivet over the fender (as…

I have a 2020 Model X and have ordered three different sets of fenders for it as the reviews have been everywhere. Two of them are 100% the same under a different name and had problems from the start with the flaps discoloring at stress points in production. They also only had ONE original factory connection point front and rear. However, they had three rear factory points and were MUCH BETTER "equipped" in every way. Yes, you have to put two screws on each blade, which isn't a problem since…

Fenders for S model fit perfectly. My only issue with this set is that they don't give you long enough button clips. I have 4-6 long button clips, 4 screws (which I haven't used) and 4 buckle clips that work great. So the kit tells you to reuse your old factory button clips, but it doesn't fit without a lot of hassle. So I found old Toyota button clips that were longer than my old ones of the same diameter and they fit all the holes. The bottom front hole had to have a special clip for the…

Installed on a 2021 Tesla Model 3. Filled with debris. They looked like a more attractive fender design. As with all others mentioned, there are no instructions on how to install it. Use the rivets provided. I didn't drill any holes. I installed ppf so I didn't use tape to keep them from rattling. Also deducted a star for not recommending it. For the front: Use a plastic spatula or screwdriver to pry out the factory rivets. Attach the top of the fender to the car, slide it onto the body with…