PRILINE TPU-1KG 1 Review

Value for money here is excellent. The thread itself seems fine, but I'm having some issues. Here I use a Bowman tube. I do not recommend using it with Bowmann tube printers. It will work, but the material is so soft it will almost certainly get stuck. In the event of a jam, you must remove all filament from the printhead and tube to continue. This is because the thread is too soft. But as far as print quality goes, you'll need to make some adjustments to your slicer to get the prints to work…

TLDR; except when not printing), retract 1.6, flow 115%, I'm printing on a standard Ender 3 Pro. I finished 1 print at 35mm/s, 215 hot end, 65 bed retract at 1.6. My first print didn't have good layer adhesion, they separated when the part was bent, and on subsequent prints the filament got stuck in the feed mechanism halfway through the print. 20mm/s I increased the print temperature to 230 to also reduce the pressure on the gear. Layer sticking was caused by insufficient extrusion (filament…

The important thing to know is that it's fairly semi-flexible. This means it feels like hard rubber and doesn't flex much (also depends on what filler you use). This can be for or against, depending on the intended use. I have an Ender 3 with Direct Drive mod. EDIT 2: I've been printing with this filament for quite some time and I'm blown away by the quality of my prints. Layers look perfect, prints are durable and beautiful. I just had to log into my Cura profile. I get much nicer prints with…