🔥 Red Dragon HT 1 1/2-10 CR Propane Vapor Torch Kit - 50,000 BTU, Enhanced SEO Review

Little assembly required. The flashlight works great and I often use it in cold temperatures where a more flexible hose would be nice.

I use this hard to find kit to heat electrical PVC pipe and it works great, even better than my $300 Goss burner kit for a fraction of the cost .

we do tons of roofing work and were looking for a small torch for small jobs. that works great. large BTU and small enough to do all corner burns. It's a must if you're burning tons of roofs.

The torch is well assembled and works great. I mainly use it to preheat metal in my workshop and its compact size, built in stand and cheap fuel make it a good addition to my other torches. I am very happy with it.

I had five or six of these, I was going to order 11-2 today but I realized I bought it in February of this year so I feel like I should get a replacement at n /c need. The area where we use this lantern requires this size, otherwise I would have ordered something else.

I use it to heat PVC electrical wire, most torches have a head that is too big and will heat the PVC to the point of fire before heating it fully to make it flexible , this one is a lot more forgiving in that regard and seems to heat up the pipe quicker than the 100k burner I have.

Connections seem loose I can smell a gas leak behind the regulator. I don't think the regulator will fit because of the tank freezing at the connector and outer tank bottom. From my grilling experience, these are signs of a bad controller. I used plumber's tape to attach them firmly. I will test with my homemade oven but I like something more reliable and better even if it costs more.

The HT 1 1/2-10CR Flashlight is a well made shop light. The construction, fit and finish is very good and the 10ft hose is a good length. The balance is good, the knurled adjustment knob turns freely and smoothly, and the burner produces an even flame. The attached stand is a nice feature and allows you to set the burner up safely without having to turn off the flame completely. The included strikers and flints are also of good quality and work well. I really liked this burner which is used in…

Looked very nice. Well built, made of thick-walled tubing, it looked like quality fittings. Super cheered. But the flame sized pen seems like the cheapest they could find. It's soft and spongy, and if you adjust it a little, it actually reverts to the old settings. You know, I'm already at $95, just spend the extra $5 and stick a decent pen in it. As it is, it's either on or off. There is no fine tuning. Update: 2 years later and it's unusable. Rust spurts out all the time. The third time I had