🚗 ReliaBot MGN12H Carriage with Enhanced Anti-Fall Strips Review

Bought while I was upgrading my 3D printer to linear rails. As with any linear guide components you buy online (except Hiwin or Steinmeyer), you'll have to disassemble them to clean them of shipping grease and re-grease them yourself. High-quality ball bearings and mounted on a Chinese rail without play and smoothly. Although many use silicone grease for these bearings, I would recommend using machine oil as it is a roller bearing. Using a good medium weight motor oil also works great which…

Can detect lack of play in bearings. After a bad experience with the normal green/red bearings, they turned out to be very good and at least match my other ones in terms of color. - Lubricated before use, I found them impeccable and absolutely no rubbing on the rail. Mine have clearly been pre-cleaned and reassembled, which is not the case for many. I can only speak from personal experience but they were lubricated with clear oil and ready to go, not clogged with grease to be removed and not…

Do not remove the rubber end stop as the bars will come loose and small bars will be scattered everywhere. They don't get attacked very well so be careful, thread the zip tie through the hole when you get it or something so you don't chase the fences. When you do this, you can slide the sticks back in between the wire by gently rocking the stick back and forth, and then add more until they're fully seated. if any fall out well. Just fit this sliding thing firmly and deeply into the rail. Screw…