🖨️ Enhance Your Printing Experience with Reprapper Gray Printer Filament 1 75 Review

I bought this material because I was printing long, thick parts that kept deforming. It's marketed as "Low Warp" so I decided to give it a try. I had a terrible writing experience with it. It warped so much that I had to go back to the basic Revain thread I used before (see image for comparison). I spent 3 days and a half spool trying different print settings but could not get acceptable print quality. I've tried glass, smooth pei, textured pei, hairspray, glue stick and even an Overture…

My spool was within tolerance (slightly oval, average 1.76mm, max measured 1.78, min 1.74) and prints well like ABS plastic . Body temperature 50°, bed temperature 110° (Geckotek surface), hotend 240°. Excellent layer adhesion at 240°. Wrapped well, not too tight and not flipped to one side. The spool isn't the one I've seen from the RepRapper before and I like this one a lot better, the big open hole without the weird smaller inserts. The new coils are not deformed like before. Came with a…

When trying a new product I usually try to decide when in doubt but let's be honest this yarn is relatively cheap, not much better than the competition, hopefully of the same good quality and it's coming also from CHINA? Well, like I said, the thread was available "next day," so there it is, and very reasonably priced, so there it is. I was really impressed with their product page - I know it's weird but they really made an effort to not only promote the product but their customer service by…