🔧 42 Pcs Rotary Tool Accessories: Diamond Cutting Wheels (15pcs), Resin Cutting Off Wheels (15pcs), Hss Circular Saw Blades (6pcs) with 1/8" Shank for Wood Metal DIY Craft Review

This product is not worth it Tried it worked great Unfortunately I went too fast and the shaft bent The other one that comes with it doesn't even work properly They are screwed together and doesn't work unscrew falls apart And that's it😭👎👎😡 ps made in china so cheap

These cutting discs were used on a bathroom tile project. I had to make cut outs for faucets, shower heads etc. The tile was 1/4" thick ceramic. With so many slices to cut I figured I could go through all ten slices and hoped that would be enough. I used two and the second one still has life. You MUST bring a spray bottle with you Use water to keep the disc cool during use and the discs hold their edge amazingly Highly recommend.

I've only tried one of the cutters so far but the others are pretty much the same design so very good. I use a cutter to cut thick acrylic plastic to make handles on my lathe. The cutter I used worked very well. Cuts quickly and very efficiently. I noticed that the cutting blade doesn't seem to be installed so it can get stuck in the cut if the cut is deep enough. But that's just an operational consideration, not a criticism. I look forward to using this set for a long time. Also a good case.

Either the large collet for particularly large saw blade shafts is not included or my kit was sent without this part. Saws are useless without this collet. All other cut-off wheels are designed for use with a standard shank and are suitable for Dremel and all other similar tools. The quality is very good, but you will need a larger collet if you want to use the supplied saw blades. I tried to notify the seller but received no response.

I had a scary moment with this rotator that could have resulted in serious injury. The shank with the wider wood saw tip bent on its own at higher RPMs (still within the RPM stated on the blade) and I didn't even touch the wood at that point. This saw is sharp enough to lose a finger on it and I don't even want to think about what might happen if it breaks and flies away. I unplugged it from the wall as that was the quickest and safest way to turn it off. I've learned my lesson. From now on I…

After reading the reviews I noticed a pattern. The bent spindles appear to be due to people not putting the spindle COMPLETELY INTO THE CHUCK. How else could the spindle be bent in the middle? I bought the set because it was cheaper than the big department stores. I have tried several blades on projects and they have worked well. I use a dremel at 12-15k rpm with a very light touch. So far there are no problems. Does the job I bought it for. Remember the spindles MUST go all the way in, they…