🚀 Enhance Your Lifted Ram Truck's Performance with Rough Country Upper Control Arms – Fits 2012-2018 Ram 1500 4WD, 3" Lifts – Ensure OEM Alignment with 31201 Review

The best value upgrade for your stock upper arms. I've ridden it about 500km so far. There are no issues to report. Good job, rough country.

I liked everything about this product except the fact that it doesn't work with the 6 inch strut jack. And no store that I know of carries 3 inch spacers to adjust the angle of the arms. Burn some new tires. Learned from my own bitter experience. There are several off-road zone levers to fix the problem.

Rough Country did it again. I used them when installing a 3" front and 2" rear lift on my 2017 Dodge Ram 1500 Laramie 4x4. Fits perfectly in the front and gave me the clearance I needed so I couldn't get out of the stock upper arms. These are a MUST BUY if you are installing anything over 1.5-2" risers or rack spacers as standard arms will not do. I am very happy with the purchase and would definitely recommend to anyone putting the kit on themselves. Go Go ahead and spend your money on getting

They were easy to fit, no need to watch any youtube videos, just loosen the 18mm bolts on the bushings, loosen the ball joint nut (make sure you have it), take the lower level nut off, knock it out of the control arm within an inch of its life, or knock out the ba-jezzus to loosen the ball joint, then reverse. 25 minutes maximum if you take a coffee break. My only complaint was with the nut and gasket that comes with the kit. When the spacer goes over the nut and the nuts provided don't fit the