🌊 Ultimate Waterproofing Solution: Discover the Schluter Kerdi Pipe Seal 3/4 Review

Kerdi can get too thick if you add inside/outside corners and those penetration seals. Some installers splice Kerdi panels end-to-end and use Kerdi tape to join them together to minimize thickness increase. It would have been a much better product if he had used the Kerdi strap.

In 2010 I replaced a leaking shower with custom tile using a Schlueter shower system (try saying that five times faster!) and was quite impressed. This is a very well thought out line of products that makes it easy to go waterproof which is the only thing you need trust me. Watch the free DVD or online video if you are planning to build your own tile shower. Yes, some parts can be a little pricey, but I was able to get a good deal on a pre-packaged shower kit by shopping online. I just had to…

I did not buy this for use in the Kurdi system. I actually use HardiBacker which is covered by Hydroban. It seems logical to me that the most likely place for water to get past your system would be running down the wall surface and then over the pads covering the hot and cold plumbing inlets. Often the opening around these two holes is too large for a good seal. So the water will most likely flow through these pipe passages and then end up in your wall. The rubber grommet on this product fits…