🔗 Senmit 30 Pairs Stainless Steel Adjustable Angle Cable Railing Hardware – 1/8" Wire Rope – Marine Grade Kit for Wood Posts Review

Well made product, good quality mounting screws included. A hydraulic crimping tool is required to properly compress the trunks into which the cable will enter.

I installed this wire track system last week. Easy enough to install once you have measured the cable correctly. Stainless material is key. We offer to buy a hydraulic crimping unit. Made life so much better.

I have used many wiring systems and these were the easiest to install. They rotate more than most. Another brand I used had a max temp of 30 degrees and my ladder was at 37.5 degrees. They managed the extra step of the stairs with no problem.

Good product I definitely recommend it to everyone. The quality is excellent, my DIY project turned out very well. I would give 5 stars if the seller provided clear installation instructions. I had to spend a lot of time looking for recommendations and advice. I'm not a professional and have never done anything like this before. My biggest concern was the length of the wire and now I can tell you from experience that you need to cut it 1.5 inches to make room for the tension.

Incredibly easy to use, I used these crimp pins on an aircraft deck railing system. The company also offered other accessories needed to complete this project. Much easier to use than a single threaded end piece. Simply insert the 2 included screws into the rack and the crimp is secure. Highly recommend this if you are doing any cable project. Tip: get some expensive pliers. The cheap ones will give you more headaches and muscle power than they're worth.

Brackets appear to be of good quality. I started connecting them to my rods (rather thick aluminum). I drilled a very small pilot hole for the screws. They are self-tapping. The head of the self-tapping screw seems to be too big, so the screws don't hook strongly when screwed in. The screws only turn once tightened and do not hold the mount in place. I'll have to buy bigger (non-self-tapping) screws and try to attach them. The project is on hold until I find new screws. I'll report as soon as I