SKF 28600 Axle Shaft Seal Review

This gasket is designed for the external duct on the 98-04 f250/excursion; However, this is not a seal with an internal metal dust cover. If you need this seal number 28603.

Yes, this one fits the 2004 F250 Super Duty. Before installation, clean the body of rust. USE the installation tool or buy another one as you will need to hammer it to install. Firmly!

Replaced both front axle outer oil seals on a Ford F350 in November 2019 (20 months and approximately 12,000 miles ago). Recently while lubricating the front end I noticed that the outer rubber band was hanging from the passenger side seal on the axle propshaft. The driver's side seal looks good. For now I consider it a failure of one seal and hope the other one continues to work properly. SKF has to replace my seal due to poor quality.

Factory seal, 2002 f250 Superduty. Thank you Revan I bought the tools to install the infill. I'm not sure how you would have done without it unless you have a lot of experience or I've thought about it too much. A thin film of red grease helped with this, I did this after putting the shaft back into the diff. I couldn't find any information on how to do this. It seems to have worked. made sure i started with a square shape, a small brass rod will do here,

Be sure to purchase an installation tool so you don't damage the print like I did. I've been told that installing an axle oil seal is easy so you don't have to spend money on an oil seal installer. After bending the gasket I took a picture and sent it to the mechanic who told me it was easy to install. Did he say what seal it is? He thought I was talking about the gasket at the end of the axle housing. The tool costs $60, which I think is work. I managed to push the seal and so far it's…