🔧 Retractable Workbench Caster Kit – SPACEKEEPER Review

I was a little nervous ordering these reels but after reading many reviews I decided to take a chance. I installed them on a newly built six drawer 3/4 inch plywood miter saw with two open cabinets. Needless to say, it's pretty hard. I took the advice of many reviewers and didn't even try to use the included fasteners, preferring to use stronger screws. Installation was very easy and took about 1 hour to install 8 casters. Although my station hasn't loaded yet, I'm optimistic it will carry the…

I bought some rolls from my local hardware store for my cnc router table. I had a real problem with the spinning reels, so I often kicked them into the right alignment. I installed these rollers and they spin freely and easily. I can turn the table with two fingers and I can lift the levers to make the table fall to the ground. When the router needs some extra stability or starts to run, I just lower the table and it becomes nice and stable. Sometimes it can be difficult to push the levers down

Bought these out of curiosity about how good they are. I installed them on a 5hp supercharger. with 80 gallon tank. Probably over the weight limit, they worked great. The lift pedal is not impressive. You usually have to raise the supercharger a bit to lower them, big deal. The ability to move a 250+ pound compressor when I want to clean up afterwards is just awesome. I have already bought the 2nd set and installed it on one of my desktops and it works great. The legs are metal so I drilled the

I needed a BENCH that would withstand the planing and standard adjustment of the woodworking part on its surface to make it mobile. A simple set of locking wheels won't help; didn't even take it seriously. This solution is actually perfect. I side mounted mine as I didn't want the obvious tripping hazard so they are side mounted/inserted. This is the reason for the four stars for the installation. Otherwise you will get a template that makes it very easy. I just built this bench, it only weighs

I bought these casters for my workbench (about £190 plus all the rubbish that happened to be on them at the time). I set up a workbench against a wall and then place it in the center of my workshop (a tent in the garage) as needed. These roles meet all requirements very well. I modified the roller arms by drilling two holes for two screws in each of the roller arms. Then I screwed the 2x4 piece onto the top of the two left pulleys and tie them to the 2x4. I did the same with the two right…

I purchased these videos after reading online reviews and looking at similar products at local stores. What I like: 1. They're pretty durable and work great as long as they roll on a flat surface. They are definitely not for uneven surfaces. If you want wheels that roll over dirt and uneven surfaces, you need to buy larger diameter wheels.2. They look cool - the color combination is attractive and stands out from other regular brands. What I don't like: 1. I agree with other reviewers - screws…

Too bad I didn't see them many years ago. weeks ago. I replaced some of the smaller casters with 5 inch tall casters (front swivel, rear non-swivel) that didn't bind. Bad idea. Bought them and replaced the castors with these, mounted according to the sketch. Please note one of the attached photos contains all the instructions you will receive. I added a note that might be helpful to you. Things to note: 1) 1.57 inch size should be 40mm but is actually flexible. The closer to the bottom of your…