🔒 Spectra Premium LO01 Fuel Tank Lock Ring: Reliable Security for GM/Jeep Vehicles Review

I think they will work on any H-body fuel tank. Check out the installation instructions on my YouTube channel @BurnoutsAndRotorblades.

It is best to replace and seal this part when the fuel pump/sensor is removed. Pretty cheap and chances are no fuel leaks. It's worth it. I highly recommend this product

The product is well made and the tension ring works well. The problem is that the o-ring is about 1/4" thick and too small to fit my 1967 Oontiac Catalina, I needed a 5/16" o-ring. The diameter is correct.

Perfect match for the tank we bought. No problem landing on our 90 K1500 Cheyenne. I just used screwdrivers to drive in the tabs. I mean tighten and loosen. You need to make sure the o-ring stays out but otherwise works great.

Patch 95 xj. A metal ring will do, but is lighter than the original. The o-ring was fine, but you will need to glue it to either the tank opening or the pump assembly as it will move too much when you try to hold the assembly and attach the metal retaining ring. I ended up with an o-ring but with an old metal retaining ring.

Good fit. If you can test the finished job by filling the gas tank with water before installing the gas tank, do so. Because it's hard work after you fill up the gas tank and find a leak. I bought a new fuel tank that was made in Canada. Then welded a new filler neck. When I installed the rubber O-ring that came with the new tank, it didn't seal properly. Even though it was fully dressed. So this new part seals the transfer line/fuel tank. Many Thanks.