⚡ Boost Performance with Spectre Performance 743 Single Plenum Air Box Kit Review

I would not buy again. Parts were missing, but Revane sent another kit to steal the parts and get the rest back. The problem is where the cylinder and filter plate meet. The code filter is mounted on the plate. Then the cylinder is screwed to the plate. Screws are cheap little hex head screws. They are already rusty and will come out after a few filter cleanings.

I installed a Holley Sniper EFI system on my boxy 1989 Suburban body. I finally found the perfect fit for this mod. This baby actually fits both ends. I had to make a small flat metal bracket to hold the air purifier in place. The kit had a great aluminum mounting bracket, but it was too short for my application, so I made a longer bracket made of steel, very similar to the one in the kit. Simply replace the airbox with this head and the air filter on the main mount fits directly into the…

First of all, no instructions, manuals, advice, nothing. Now I'm not stupid, so I could understand it, but it frustrated me a lot at times. Due to the fact that my engine was an inline 6, I had to install a carburetor gasket to properly install the blower box. Finding a good place to mount the filter housing support brackets was a challenge. I also had to make another mount to support the other end of the case. Took me the best part of 5 hours. As a result I have an excellent cold air intake…

I was looking for a good air intake for my truck and after a lot of research I decided to give this kit a try. It was so easy to install. I was able to use the factory fender air intake and just plug in the 4" plug (included), use the spring clips to press the plug against the air filter housing, and then another against the factory fender air intake. The size of the air cleaner housing was perfect for installing onto the existing factory air manifold bracket. I then attached the single…