Universal open and 4 hole spacer for Holley, Edelbrock or AFB carburetors. 1 inch thick to help increase air/fuel velocity. Gaskets and hardware included. Easy to install.
Everything fits perfectly I have used it on a Edelbrock Eps 2701 intake and a 1406 Edelbrock carburetor on my SBC 350, it all looks fantastic together. good part good price
Pretty good part, it can be used in a number of ways, the inserts are a little tight but that's normal, I put it on a new assembly so it doesn't have it yet caught fire. but I'm sure it will be good, and at an unbeatable price
When I received it it was OPEN, someone took the studs and nuts from this kit. It doesn't work without her. You get very annoyed when you put everything on the engine, but something is missing.
Everything fits perfectly I have used it on an Edelbrock Eps 2701 inlet and a 1406 Edelbrock carburetor on my SBC 350, together they all look fantastic. good part good price
Pretty good part, it can be used in a number of ways, the inserts are a bit tight but that's ok, I put it on a new assembly so it hasn't clamped fire yet , but I'm sure it will be good and for the price you can't beat it
. When I received this it was OPEN, someone removed the studs and nuts from this set. It doesn't work without her. You get very annoyed when you put everything on the engine, but something is missing.
Ok. This was not the case when installed on a perfectly flat surface. I had to sand it by hand. Both metal and plastic insert. The plastic insert has a raised arrow that can cause a leak between the carburetor or inlet. I had to sand everything down to make it work. However, for the price and few cubits, it works well.