🔧 Steelex D1041 Tapered Countersink 22 Piece: Achieve Professional and Precise Countersinking Review

Good bits and countersinks work great with the depth gauge - that's when I discovered that the set screws in the countersink and depth stop are specially sized and only work with the one hex wrench that comes with the bits - which is bad considering I have hundreds of hex wrenches, luckily I could find a standard size set screw at a local hardware store and replace them all.I've had no other problems and work with furniture grade film faced plywood and drill 2.5" to 3.0" deep holes.The conical…

I bought this set because the idea of countersinking in one step with the correct size pilot hole seemed like a time saver to me. The set is for those points when you don't need to move the countersink to the point to install a shorter screw. The set screws that hold the countersink in place are of little to no use when moving it onto the flutes of the drill. Thus, the sinker slipped and wobbled. This set will go in the trash when I receive the Rockler Pro 3-Piece Drill Set. This system uses a…

I'm on a tight budget and can't afford the more expensive end products. I found these and decided to try them out. Care must be taken with this: as another reviewer noted, they don't do as well when running a countersink locking ring around the flutes, but I've had good success aligning them carefully on the drill and not in the flutes. and there were no problems. The bits are strong, sharp and have not given me any problems when working with pine or oak. They have their quirks typical of their