🔧 Sunex 2622: High-Quality 1/2-Inch Drive 22-Mm Extra Thin Wall Deep Impact Socket for Precision Jobs Review

Recommended for installation of Fisher/Paykel Drum Bearing Kit. However, I had to make the wall of the nest even thinner to fit through the drum.

Sold as thin walled to fit inside dryer opening and did not fit near. I had to sharpen it to fit. Should have been because it was sold as an item that would fit with replacement parts.

This is by no means a "thin wall" outlet. I bought to gain access after selling narrow bore lug nuts. It has the same wall thickness as the 22mm socket in my "Standard" set. Looks well done. I decided to stay in reserve and not pay for the return shipping.

Needed to remove a round nut from a fairly thick aftermarket aluminum wheel. It wasn't thin enough to go into the nut hole and pull the nut out. I ended up buying a cheap 22mm head and sanding the outside with a bench grinder, which worked. I can't say it's particularly thinner than any other power socket.

This product was shown as an option for a bearing kit for Fisher Paykel dryers. He claimed it was a very thin socket. Good thing I have a bench grinder. In its current form, this bushing does not fit into the bearing bore that receives the bearing shaft. I would advise you to make a disclaimer if you are selling this item with Fisher Paykel parts.

Robust and high-quality construction. I bought this to remove a bearing from a Fisher-Paykel dryer and was warned that I would have to grind about .020" diameter to fit the dryer bushing. The extra length of this socket came in handy when working with a fitting that is under or behind an obstruction. The metal had good composition as it took the belt sander and drill assembly three tries to remove .020"!

I bought this driver so I can fix my dryer. I had to sand the outer wall as I knew it to fit the drum. Then I realized that for some reason the screwdriver has a curved and angular interior at the very edge of the screwdriver hole - it can't directly touch the nut I'm unscrewing! In this case, the nut will be pushed out, maybe a millimeter and a half, this driver will not catch. I had to sand the entire outside edge to get to the flat surface of the inside hole so I could mount it onto the nut.

Ordered to replace bearing and shaft in Fisher Paykel Smart Load Dryer. According to many YouTube DIY videos, you need a thin wall socket to access the nut on the bearing shaft. Many videos describe how to "grind" the bushing to fit the hole holding the bearing assembly. On Revain's website, this is the recommended accessory for bearing and shaft assembly. This is a standard size 22m or 7/8 head. It will not work. Went to Home Depot looking for a "thin wall" container and found it was identical