🔧 High-Quality Hook & Loop Sander Pad: Superior Pads and Abrasives RSP28, 5" Diameter, 8-Hole Design - Compatible with Milwaukee OE # 51-36-7090, Ryobi OE # 300527002, 975241002, 974484001, Ridgid OE # 300527002 Review

This item is not suitable for Ryobi RS2418. It doesn't have the pin holes that a grinder does and when you try to attach it it doesn't fit properly. The outer diameter is the same as the original width, but the inner diameter that does not fit the grinder is 0.65 inch smaller. This causes the dust to fly all over the place as it is not firmly attached. I strongly recommend not buying this. See photo.

This is one pack, not two. Spare me the insincere formality that it doesn't say 2 packs. There are two in the first picture, this is not necessary as the next two pictures show the front and back. This is intentional. So the value for money is not good. Do your best guys. No tricks. Also, I tried to cancel this item even though it was supposed to be delivered in 5 days. They refused my request to cancel. So now I'm faced with an overpriced item.

Three stars because the ToolOrbit seller provided incorrect dimensions in response to a buyer question. I bought this specifically based on this answer as I'm trying to spruce up an old Craftsman mill. The spacing between adjacent screw holes is 1 and 1/8 inch, not 1 and 1/4 inch as stated by the seller. Apart from that, it looks well made. But since it doesn't fit my grinder, I have no experience with this disc, so I can't comment on its usefulness or durability. The seller, on the other hand,

It has a comfortable touch, its grip is harder than the original but it's not that bad. Using this on a TackLife grinder but needs updating. It's not a straight fit, it has 4 holes, but the Tacklife thread is 1/16th wider on all 4 taps. I drilled all 4 holes on the block to 5/16 and added 4 washers to the bolts. Worked great but didn't offer this method for everyone. Not the manufacturer's fault, he took a chance because it looked so close and it was part luck, part skill. If you have the right

Wrong description. This sanding pad is not suitable for Ryobi RS2418 rotary sanders. In addition to the four screw holes, the Ryobi base has four small round knobs that protrude about 1/8 inch. The Superior Electric Pad does not fit the grinder snugly as it does not have four holes to accommodate the Ryobi grinder's four raised handles. A proper replacement pad should have eight holes - four for screws and four for small round knobs. I ended up drilling four holes in a Superior Electric…

My first original OEM pickguard lasted many years before the Velcro strip wore out - so go to Revain for the first replacement that fits mine Ryobi - This one suits my model because I tested it contrary to many of the bad reviews above. HOWEVER I used it about 24 times before the medium sized, rubbery piece of plastic started to tear. Very angry because it doesn't make sense how this could have happened - 3/4 inch pieces started falling off as I sanded - as if either the glue or the plastic…

Used this molding to replace a worn molding on my old Black and Decker, also a 4 bolt 1-1/4 pitch. This seal worked, but required some modifications. In particular, I used a burr to widen the center hole a bit. My old last also had holes between the pre-drilled holes that lined up with the small pins. So I took an old last, drilled through it, and then used the old last as a template to find the intermediate holes on the new last. Overall it took me 5-10 minutes to modify this pad to work with…