Header banner
Revain logoHome Page
1pk welding argon co2 gas flowmeter scale tester - measure flow meter for mig tig welder welding logo

1PK Welding Argon CO2 Gas Flowmeter Scale Tester - Measure Flow Meter for MIG TIG Welder Welding Review

3

·

Terrible

Revainrating 1.5 out of 5  
Rating 
1.7
🔨 Welding Tools, 🔧 Automotive Tools & Equipment

View on AmazonView on ЯM

Media

(4)
img 1 attached to 1PK Welding Argon CO2 Gas Flowmeter Scale Tester - Measure Flow Meter for MIG TIG Welder Welding
img 2 attached to 1PK Welding Argon CO2 Gas Flowmeter Scale Tester - Measure Flow Meter for MIG TIG Welder Welding
img 3 attached to 1PK Welding Argon CO2 Gas Flowmeter Scale Tester - Measure Flow Meter for MIG TIG Welder Welding
img 4 attached to 1PK Welding Argon CO2 Gas Flowmeter Scale Tester - Measure Flow Meter for MIG TIG Welder Welding

Description of 1PK Welding Argon CO2 Gas Flowmeter Scale Tester - Measure Flow Meter for MIG TIG Welder Welding

Two Scales : Ar & Co2 . Suitable for the Nozzle Caliber range of 4 - 30mm. Flowmeter tester scaled from 0 - 25 litres per minute in one litre graduations, used for testing the gas flow at the Mig or Tig torch. Simply place the tester over the Mig or Tig gas nozzle and the gas flow is measured from the top of the ball, can be used for all gases. Designed to check gas flow on Tig or Mig torches.

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    2

Type of review

Revainrating 1 out of 5

I'm not sure I trust the reading.

The ball likes to stick to the ground and shows no flow. It reads a few CFHs lower than my Miller's gauge, so the question is - which one is correct? If I want to stay grounded, I will continue to believe what the Miller sensor tells me and give up on this thing.

Pros
  • Certified
Cons
  • I won't say anything

Revainrating 3 out of 5

Nice little gauge.

The rabbit got stuck on the first try. I had to manually move it to make it work. After freeing him, he found himself at work.

Pros
  • Welding devices and accessories
Cons
  • I'll write later

Revainrating 1 out of 5

I'm not sure I trust the reading.

The ball likes to get stuck in the ground and shows no flow. It shows a few CFHs under my Miller flow meter, so the question is -- which one is correct? Since the ball likes to stay down, I will continue to believe what the Miller meter tells me and give up on this.

Pros
  • TIG welding machine
Cons
  • Miscellaneous Miscellaneous