🔒 Tigeracing Tie Down Anchors: Retractable D Rings for 2015-2021 F-150, 17-21 F-250, F-350 Super Duty, and 17-19 Raptor - 3000 LBS Capacity (Set of 4) Review

Please note that the front brackets are offset front to back as the hole in the plastic cover of the F150 rail is offset front to back. For the rear brackets, the part is centered in the plastic. I didn't know this until I got them and went to install them. Before that, I was wondering if there would be a side-to-side shift.

If you put everything in by hand I don't think it's that easy to remove during installation. I don't know why you used a 4 screw electric drill. They fit perfectly, look great and are very durable. I'm glad my long bed has 19 f250 mounting options in the middle of the bed. Front and rear is too little ford.

Rear fits but front does not fit. Rather than sending it back and ordering the front and back separately, I sanded the front panel down enough to fit the chuck cutout and then painted the metal edge a matte black paint. Works fine afterwards, but order front and back separately. Fits the trunk lid of the BAK X4 revolver.

They are really well designed. Much better than I expected. Top processing. Worked great on my 2021 Ford F250 XLT Premium short bed. You have to pull them out, but that doesn't stop them. I see that adding push to the popup gets them out of that price range. Will pay attention to their rust resistance and update if there is any problem. Good job Tiger Racing!

I installed these front center and rear body rails on a 2017 F350. Before ordering I checked and was sure that they would fit all three places. The rear and middle rails fit perfectly. Front corners can be used but are not suitable for recesses and must be ground to match. The most annoying thing is that the seller sent me an additional email to make sure I was happy. I explained the boarding problem with photos and never heard from them. Aside from the front corner fit issue, it's well made…

Watched the video. But. The video looks outdated and has a different model/design. I mistakenly thought that if the screws were completely removed the entire bracket would fall apart, so I only removed them to the last thread. The mount didn't fit. I looked at my build and COMPLETELY removed the 2 1" stainless steel bolts. I pulled the ring out and it JUST fit into the bed of the truck. Once it's in place pull the ring up and install the 2 -1" screws and tighten. 14 minutes - DONE! Suggestion…