Header banner
Revain logoHome Page
universal adapter protector lifting 10x4 7cm logo

Universal Adapter Protector Lifting 10X4 7Cm Review

2

·

Very good

Revainrating 4 out of 5  
Rating 
4.0
🔧 Trailer Accessories, 🚗 Exterior Car Accessories

View on AmazonView on ЯM

Media

(4)
img 1 attached to Universal Adapter Protector Lifting 10X4 7Cm
img 2 attached to Universal Adapter Protector Lifting 10X4 7Cm
img 3 attached to Universal Adapter Protector Lifting 10X4 7Cm
img 4 attached to Universal Adapter Protector Lifting 10X4 7Cm

Description of Universal Adapter Protector Lifting 10X4 7Cm

Made of Durable rubber construction and cross slotted design, provides more cushion and crush resistance. Jack pad is strong enough to support your lifting point and soft enough to prevent bending or fracture of clamping weld and frame longitudinal beam when jacking up your car. Fits most Jacks and vehicles, please verify dimensions and ensure fitment to your vehicle. There is a slotted crossline on the top of the car jack pad, which can align with the side clip weld and protect the side, so as to prevent the frame longitudinal beam from bending when lifting the vehicle with the jack. Maximum load: 3 tons, Diameter:10cm/3.93in.Thickness:4.7cm/1.85in.

Reviews

Global ratings 2
  • 5
    0
  • 4
    2
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

Sturdy Add-on for Safer Towing!

This ingenious addition to my trailer has been a game-changer for my towing safety. The protector lifting feature not only secures the adapter but also prevents it from scraping along the road.The universal fit and durable build make it a must-have for any automotive enthusiast. The only downside? It may add a bit of weight to your towing setup..

Pros
  • Provides protection for universal adapters
Cons
  • May cause inconvenience due to added bulkiness of 10x4 7cm size

Revainrating 4 out of 5

Check the dimensions of your jack

These pads are very strong. The distance from the top of the pad to the bottom of the groove is exactly the same as the weld on my Lexus and Toyota. This was the size I was concerned about, to ensure the weld reaches the bottom of the groove so the gasket doesn't press too hard on the horizontal flat sides next to the weld. The metal is thin and I don't want to risk bending it when the car is on the jack. However, the distance between the cheeks of the chuck where the tip of the jack goes is a…

Pros
  • Confident
Cons
  • Out of fashion