Header banner
Revain logoHome Page
πŸ”ͺ carbide cutter for acrylic and hardwood by uxcell logo

πŸ”ͺ Carbide Cutter for Acrylic and Hardwood by Uxcell Review

3

Β·

Excellent

Revainrating 5 out of 5Β Β 
RatingΒ 
5.0
πŸ”§ Milling Accessories, πŸ”ͺ Cutting Tools

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”ͺ Carbide Cutter for Acrylic and Hardwood by Uxcell
img 2 attached to πŸ”ͺ Carbide Cutter for Acrylic and Hardwood by Uxcell
img 3 attached to πŸ”ͺ Carbide Cutter for Acrylic and Hardwood by Uxcell
img 4 attached to πŸ”ͺ Carbide Cutter for Acrylic and Hardwood by Uxcell

Description of πŸ”ͺ Carbide Cutter for Acrylic and Hardwood by Uxcell

Shank Diameter: 3.175mm / 1/8"; Cutting Diameter: 0.8mm / 0.03"; Number of Flutes: 2. Cutting Length: 3mm / 0.12"; Overall Length: 38mm / 1.5". Suitable material: Nylon, Resin, ABS, Acrylic, PVC, MDF, Hardwood. Good for 2D relief sculpturing, cutting, engraving, slotting, milling, etc. Carbide can run at higher speed than high-speed steel, resisting abrasion and high cutting temperature.

Reviews

Global ratings 3
  • 5
    3
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Excellent Milling Accessory

The Uxcell carbide cutter is a fantastic accessory for anyone who is looking to mill acrylic, hardwood, and other similar materials. According to my experience, it provides a smooth and clean cut, with a minimal amount of debris left behind. Its durability is also noteworthy, as it has lasted me through multiple projects without showing any signs of wear and tear. However, one downside is that it may be a bit on the pricier side compared to other milling accessories.

Pros
  • Smooth and clean cut, durable
Cons
  • May be pricier than other milling accessories

Revainrating 5 out of 5

More expensive is not always better

This nozzle outperformed those that cost me over $30. Super impressed with the quality for the price and will be a repeat customer.

Pros
  • Shaft diameter: 1/8 inch / 3.175 mm; Cutting Edge Diameter: 0.8mm / 0.03in; Number of flutes: 2
Cons
  • Can't remember

Revainrating 5 out of 5

quality cutter.

Please note that I ordered a long one. This was a mistake as I don't use the full length of the bit and as a result it tends to vibrate when bent. If I had to do it again I would order a shorter one.

Pros
  • Carbide can work faster than high-speed steel, resists abrasion and high cutting temperatures.
Cons
  • No power