🔧 Premium Quality Walker Exhaust 31531 Exhaust Pipe Flange Gasket - Ensuring Optimal Sealing Performance Review

Does not fit Period 2003 Honda Accord 2.4 DO NOT BUY On top of that they were a day late and I was pissed. I will buy auto parts elsewhere again

The inner diameter is smaller than the exhaust pipe where it is to be installed. You'll have to use a utility knife to scrape off a significant amount of caulking material to get it to fit. This will almost certainly shorten the life of the seal and is a messy mess. I will pay for the OEM seal if I have to rebuild it.

I ordered this because my catalytic converter was stolen and I opted for the catalytic converter screw and pipe (1pc). I installed all the parts in Honda Element 03. Installation was easy for this part. Walker Part #31378 is for Downstream (after Cat) and P/N 31531 is for Upstream (after Manifold). The upstream installation required a bit of cleanup on the inside of the washer/donut. Also, the upper part is different from what is shown in the picture. In general I am very satisfied with the…

Works for manifold to bleed a 2007 Honda Element LX 2WD with a small modification. In particular, since the inner diameter for the header pipe is somewhat small, little scraping of the inner material is required. It didn't matter much. I used a utility knife and took my time. It only took a few minutes to fix everything. Just don't scrape off too much material and don't expose too much wire mesh underneath. In any case, if you take a little more I'm pretty sure the spring bolts will put enough…

Full Disclosure - I did not purchase this gasket with long term plans. I was in dire need of a gasket as the original gasket was ordered and was expected to take a couple of weeks to ship. Installing this gasket was much more difficult than the original Honda gasket. Its inner diameter is a few millimeters smaller than the outlet of the exhaust manifold, which makes a deformation-free assembly almost impossible. The resulting gasket was somewhat compromised, but it held up well for me until the

The inside diameter is too small to fit over the exhaust manifold on my Honda Element. It couldn't be done without filing and sanding the ID card to make it bigger. I had to remove so much material that I sawed off the core of the wire. And fillings of this type are not taken with pleasure, so they began to crack. I don't think it will last at all. I'm already looking for a replacement. What should have been an easy 20-30 minute job turned into an hour and a half trying to figure out why it…