Weistek 3D Printer Resin: High Precision UV Curing Photopolymer for SLA 3D Printing Review

Bought this resin on a friend's recommendation. The packaging was fantastic, the bottle was in a pimple suit and the bottle had a sealed aluminum cap. Shake the bottle and leave as Weistek recommends. I poured a little into the vat, it was so clean I almost didn't notice when I pressed the fill mark on the tank. My print settings: 30 seconds, 5 base layers, 2 transitions. Layer hardening time 8 seconds. It turned a little yellow which means I have to try 4 seconds. The layer time and adhesion…

This was my first standard resin (waterproof) and it worked great. I printed the first model on Mars 2 Mono. A few pluses: Faint smell. Less odor than some water washable resins I've used (eSun comes to mind). Since I'm typing indoors, smell is a big thing for me, and that goes with the ticket. - Nice color. I usually paint/finish my prints so color doesn't matter to me, but it was a dark rich grey. Looked great before I even finished it. uses fewer supports than usual. I wanted to test the…

Only ordered on the recommendation of a friend. I usually use Elegoo and get great results, but it's a bit cheaper and I wanted to reassure this friend. I can only say wow! It has practically no smell, the resin flowed into the tub very gently and the quality of the finished first prints was amazing! I can't tell any difference between this material and the Elegoo I used, except that the smell was even less. The first time I waited for the print to rise high enough to look at was when I was…