Header banner
Revain logoHome Page
πŸ”§ enhanced axle oil seal by omix-ada - model 16526.02 logo

πŸ”§ Enhanced Axle Oil Seal by Omix-Ada - Model 16526.02 Review

4

Β·

Very good

Revainrating 4.5 out of 5Β Β 
RatingΒ 
4.3
🦾 Bearings & Seals, 🏎️ Performance Car Parts & Accessories

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ”§ Enhanced Axle Oil Seal by Omix-Ada - Model 16526.02

Description of πŸ”§ Enhanced Axle Oil Seal by Omix-Ada - Model 16526.02

Inner. Left/Right Side. OE Style. Direct Fit. Limited 5 Year Warranty.

Reviews

Global ratings 4
  • 5
    3
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

Great price, but good luck with the installation.

They will never fit in my Dana 30 on my 98 XJ. I ordered the seasoned version and a simple arrow install. Wouldn't recommend it.

Pros
  • Automotive
Cons
  • No Instructions

Revainrating 5 out of 5

fit well jeep 2002 tj

as good quality time will tell. installed it on a jeep tj with a dana 30 fit was good to keep straight when installing to avoid bending the 36mm bushing worked as a punch inner axle seal front on both sides only took about 3 hours start to finish work well worth it , no more leaks while you're there to test your brakes?

Pros
  • bearings and seals
Cons
  • there are new competitor

Revainrating 5 out of 5

A pain to install but you need them.

The product fulfills its function. Take your time and properly install the seal in the axle tube. If the inlet is crooked, pull it out again and check for roundness deviations. If everything is ok, try the installation again. Such a big pain for such a small cheap part but you need them.

Pros
  • Seals
Cons
  • old

Revainrating 5 out of 5

Fits perfectly on the front axle 06 TJ Dana 30

Bought two of these for my 06 TJ Dana 30 diff. I installed a spartan lunch box locker, so I decided to replace the axle seals while I took the diff apart. I used a piece of pipe to puncture the old seals and clean the axle tubes as best I could. I deleted the seal area and then started to reinstall. As mentioned, they were *very* tight. I ended up having to get a little creative to install them. I put a gasket in the axle tube hole in the differential. Then I used a large coupler and placed it…

Pros
  • Spare parts
Cons
  • The list is long.