Header banner
Revain logoHome Page
Justin Reese photo
Anguilla, The Valley
1 Level
682 Review
52 Karma

Review on πŸ”ͺ Carbide Coated SpeTool Flutes in Inches by Justin Reese

Revainrating 4 out of 5

Good for short jobs, doesn't stay sharp for long.

Bought these for a small CNC job needed a longer range. I had to complete the task 6 times, each task took about 1 hour to cut a walnut. These bits took 3 jobs before they got boring. That's not bad for a $16 bit. Since I don't need that much time, it was definitely worth the money.

Pros
  • 1/4" shank carbide spiral cutter with 1/4" cutting diameter, 1-1/8" cut, 3" overall length
Cons
  • Not bad but...