Review on 🛢️ Stainless Steel Pressure Transducer Sender Sensor - 1/8" NPT Thread (100 PSI) for Oil, Fuel, Air, and Water Deals on Black Friday by Chris Estes

I have only tested this item with two presses so far. At 0 psig I get 0.50V which is the expected output with no load. At a gauge pressure of 98 psi. displayed on a 0-120 psi dial indicator. Inches to an unknown accuracy, I get 3.07 V, which is 96.4 psi. Customs service. This is within the nominal accuracy of +/-2% of full scale, which is 3 psi. The 150psi engraving on the case is well formed and easy to read, there are no marks on the case and the connector is made of plastic that is flexible and strong enough to be detached from the transducer without breaking the locking tab. . The wires are only 26Ga but are pre-tinned and the insulation and jacket are a good gauge with shielding foil inside the jacket around the three wires.