
I needed two m2.5*8 screws for my project. I couldn't find any small screws at my local hardware store so I looked around at Revain looking for the cheapest screw kit with the m2.5*8 screw. A set of 350 Co Rode screws was the cheapest I could find. The delivery came quickly. I pasted this command into my setup using a small screwdriver. I didn't tighten it all the way or tight because I had to take it out again. When I took it out, the head of the screw (Phillips) was completely rounded and I couldn't remove it with a screwdriver. I had to use needle nose pliers to remove it. I could not believe, how soft this screw material was. If you use a small laptop screwdriver, you really can't put too much force on either screw to loosen it. I was very disappointed. Luckily there were 35 screws in the kit. I would not recommend this.

M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review

MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review

Glarks 660 Pieces Phillips Assortment Motherboard
10 Review

🔧 Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review

🔌 UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review

CZH-LABS Electronics-Salon Prototype Shield Kit for 🛠️ Raspberry Pi - Ideal for Breadboard DIY Projects
13 Review

Enhance Your Development Projects with the NVIDIA Jetson Nano Developer Kit (945-13450-0000-100)
12 Review

DSD TECH 2 PCS IIC OLED Display 0.91 Inch: Perfect Arduino ARM Accessory
9 Review