Review on 🖨️ White 1.75mm Spool Printer Filament by Melvin Goerge

So far I've only tried black on the Ender 3 Max and Ender 5 Plus. Constant grinding, but the nozzle was fine. I have given up using it on the Ender 3 Max. I tried another PLA from the Matter Hackers MH Build collection and the printing was a dream at 205°C, 85 speed and 60°C glass bed. Set up Ender 5 Plus and decided to try this black role again. Still constant problems with loops and extruder. Tried everything. Injector checked - ok. I set up the extruder - to no avail. Went ahead and replaced the standard tube with a Capricorn tube. There are still problems. Eventually he said it was, and set the temp to 230C and the speed to 35, gradually increasing it to a maximum of 85. Ran some 1UP Mushroom as it has a lot of angles. No more sanding and beautiful, glossy, even prints. Launched a cylinder and a small dump truck with printed moving parts. Everything looks good. No more grinding! As soon as the temperature drops below 220 °C, grinding begins. Once the speed exceeds 85, the grind will begin. My optimal temperature and speed with the 0.4 OEM nozzle was 225°C at 75 speed and bed temp between 55°C and 60°C. No further adjustments. One thing should be noted. I haven't had any adhesion issues with this thread on those OEM textured glass platforms that come with the Ender 5 Plus and Ender 3 Max. I probably wouldn't buy again and just go to Matter Hackers or Atomic Filament PLA. It's scary to try white buns. Buena sure!