Review on High-Precision Non-Brittle 3D Printer Resin By HATCHBOX - 405 Nm UV Curing Photopolymer For LCD And DLP Printing, Transparent White, 500Ml Bottle by Jean Donjuan

I am overall happy with the HATCHBOX 3D Printer Resin. I did do some tests with this before getting to work and found that the exposure time will need to be increased from what I have used with other white resins from other brands. However, it's much more opaque, so that is a reasonable expectation. Once that was set, this performed well. The odor is strong from what I am able to determine from my trash. I'm careful to be handle all uncured resin in the safest manner possible, wearing a VOC cartridge respirator, gloves, covering clothing and being aware of cross contamination. I use this in my garage as it provides excellent ventilation. Personally, I prefer stronger odor from resin as it's a good indication to determine if ventilation is sufficient. My fully cured pieces do not have a linger scent. I did notice some very light yellowing in some patches, mostly due to over exposure combined with a less-than-stellar attempt to wash the piece in isopropyl alcohol before the final cure in the box light. That was my fault, but I was testing the limits for the purpose of review. I do not expect to find this under normal use.I'm pleased with this resin, I did a test to break a piece with a hammer and found that more difficult than other brands. No dings from purposely dropping the finished pieces on a concrete floor. This is a tough resin. Although this is not my #1 favorite brand for white resin, it's a close second and I'm happy to use it. I find it to be a fair value for the quality and quantity. I hope that my experience is helpful and you kindly will click the button below.