Header banner
Revain logoHome Page
Dale Rylander photo
1 Level
718 Review
33 Karma

Review on ๐Ÿ”ง Premium Fuel Injection Throttle Hose Air Flow Meter Intake Boot Replacement for BMW E30 325i 325is 325iX 1989-1991 Auto Transmission - Enhanced SEO by Dale Rylander

Revainrating 2 out of 5

Read my long review and see my photos to understand the insularity of this product. Pooh!

First let me explain that the seller was fantastic! However unfortunately the quality of the part itself leaves a lot to be desired in many places, I spent 10 euros more and ordered a replacement from another supplier which is of much better quality and almost identical to the OEM. Now it's made of a unique material that I can't describe and it's a bit stiffer than some where it should be more pliable. Landed a 7 on a scale of 1 to 10. The main problem is briefly illustrated in the photos I've added. So basically it's the rubber injection molding process that drains them. The problem is that the vent tubes like the IAC hole etc are all sealed and break the seal in what looks like a precision knife cut so there's just these random deformations and proportions messing up your flow. If it were on the 305 IROC Z it would be one thing, but these BMWs are too picky and it just doesn't work. The stream was almost closed when I received it. I tried to sand down the openings in the rubber as best I could with similar sized drill bits which I combined into holes to be a bit round and give them some flow. Then I installed it and it worked horribly, ended up uninstalling it, throwing it away and ordering almost the same thing from another vendor. Even where the locks go around the terminals, the original and other vendors have grommets so you get a nice tight fit when clamping the terminals. Well, they don't all have those edges, they're just the same diameter and your clips will fall off when you try to install them. Other providers were easy to install. Just see my photos for a small example of how you see ports closed and then I try to expand them. That wouldn't be so bad, but if you combine efforts to set the ID to the factory ID, you dilute the rubber almost to zero, almost punching through the welly to fix its mold errors. I will end by saying that they were great sellers and very understanding but a waste of my time and days of wasted time, effort and wasted waiting. After spending that extra $10 for a total of $28.95, I couldn't be happier with any other vendor's product. Oh, that's very bad. The $10 savings just wasn't worth it. thanks see pictures

Pros
  • Belts, hoses and pulleys
Cons
  • No specs