Review on 🔍 Transparent Spool with Tight Filament Diameter Tolerance (2 2Lbs) by Tyler Gannamani

Well I looked for the fluorescent orange filament and found it when it arrived it wasn't a solid color but a translucent fluorescent orange filament hahahaha that looks cool! I was planning to build an AM8 printer, I don't have an ABS case and the PLA was out of the card due to the temps so I grabbed this PETG, printed some big chunks first and wow! Prints beautifully! The diameter is really consistent, there is no snagging or anything like that on the spool and for traction. ok i have a PEI sheet let's say with PETG you need to level a little higher than normal because PETG even sticks to dirt hahahaha but it sticks to PEI so no sticking or warping issues as it prints just as easily like PLA just at a higher temp at the nozzle all in all i highly recommend it i actually ordered another roll its like 21 dll and i always said i would never pay more than 18 for a roll hahahaha , but I happily did it with the second roll I ordered. Pros: Sticks to almost anything, with a hot bed you can use glass or kapton tape, without a hot bed you can use masking tape. Prints amazing when your printer is typing. Really well wound, not a single tangle in the whole roll. constant diameter CONS: Sticks too well! Ha ha ha, I nearly ripped my PEI sheet trying to get a print out but it was my fault for not raising the level a bit higher. No more than I can think of.