🔧 TOPEMAI 47-559-11-S Fuel Pump for Kohler K341 K301 K241 Engine Magnum Series M10 M12 M16 - Replaces 12-559-04-S and More Review

good kit, be careful when tightening hose clamps on barbed nipples. I had a break in the fuel hose, there was an extra one in the kit so no worries there

Bought these despite reading the bad reviews to replace a 37 year old pump that was starting to leak. Found this new block to leak immediately after installation, worse than what I had taken off. Don't let the price and extras tempt you to buy.

Bought for a mower/tractor that I use 5-6 times a year. I was using the mower last weekend and the fuel pump is leaking on the outlet side of the pump, carefully remove the fitting, put a new ring on it and it is leaking out of the housing. Junk product will now find a better substitute

The pump works well, different design and of course cheaper materials than the 25 year old, but it works. A snap ring for installing fittings will only help you if you have snap ring pliers, but as others have said they are easy enough to install using other methods. Neither connector combo had exactly the same position and angles as the old block, so there's now a small extra fuel line loop, but it's hard to beat for price and functionality.

I have a JD lawn tractor that is over 40 years old. In the 30 years I've had it this is the first time the fuel pump has caused a problem, the order came a day early and fitted well. However, it leaked in the first two weeks. I have now found that it entered the crankcase and may have ruined the engine by diluting the oil with fuel. It will be necessary to disassemble it and look, it seems that it has lost compression and, fortunately, does not start. We'll see, big difference in cost but it…

Snap connections are not welcome. The membrane is made of thin rubber. All these fakes are the same. There's always something that's a little off. The ends of the fuel filter are smaller than we would like. How long it will take? The original had clogged and corroded fittings, so why not buy a cheap new pump? It was an old Magnum 16 with the original plastic fuel pump. The new one is in operation. I cleaned up the original and prepared it for backup. But I keep buying stuff. Let the rich send…

Firstly this pump actually works on my Kohler K301 and the hand is correct. Second, they are made of plastic and can easily break, so you have to be careful. However, this is difficult as the fuel line nipples need to be installed and slightly blocked. Communication is not easy. This may be easier if a tool was included to install or perhaps a ring was used or they were screwed in. it will be difficult for me. Also pay attention to the size of your line and the size of your nipple, this can…