🔧 Enhance Alignment Stability with ACDelco Professional 45K5012 Front Caster/Camber Bolt Kit including Hardware Review

Just to start with, they were on my 2003 Silverado 1500 RWD with coil springs. Back to that. So if you're looking at them at all, chances are one of them got stuck and you had to take it apart to get that control lever out and free. You've probably at least loosened, if not knocked out, the cam guide's dowel pins. Go ahead and throw some in the order while you're at it. In total your truck has 8 parts. I mean what else can I say? Giggy-giggy slime.

Yes! Happy as you can be. After having to cut off all the old hardware due to age and rust, I was concerned that I would end up with something that wouldn't perform as well as the original. but to my surprise they had the exact same design and fit exactly as the original. The installation went quickly and now I can straighten the front. You will only get what you need for one side, remember if you want to replace left and right side you need to order two sets for both sides. Thank you Revane…

Fitted new upper arms (Moog) and bought this gear for them. Alignment was complete and they got as close as possible, but I had to make some adjustments to my torsion bars. So I took it home and returned it a week later after adjusting the torsion wedges for more clearance and the dealer brought me in and said when they turn the screw to set the camber the screw just turns and does not move the disk. The stud is stripped where the flat meets the plate, or the plate itself is rounded. I don't…