Adhesive Standoffs Height Offset 0 6X0 6 Review

So far, so good. does what i need (Keep the motherboard above the surface of the test bench.) Also great for other projects where you need to hold the board in place without standoffs and screws.

later They fit the Arduino board but will not fit the smaller board used with the Arduino without modifying them. The glue sticks very well, the plastic seems to be of good quality. I will buy more if needed.

They don't suit my application but they seem to work for someone who can measure better than me. The posts were too wide for my openings and the legs were too wide for my suitcase. If you work in a tight circle, they may not suit you.

The offsets really make it easier to mount the PCB near the edge of the project box, which isn't possible on my other racks, without trimming one side, eliminating half the glue line. I also love them because they fit under the circuit board to support and hang the board so it doesn't accidentally short out to the case. I would buy them again.

I am very happy with these frames. I used mine to mount a relay board and a raspberry pi to the inner steel walls of my air conditioner control box for a project I was doing to automate the controls. I am very impressed with how strong the clips are and even more impressed with the adhesive used to hold them in place. Even in this air conditioner where there is a lot of vibration, these little stands stay put. I am very happy with them and would highly recommend them to anyone who needs them…