🚀 Maximize Performance with Airaid 510-608 PowerAid Throttle Body Spacer Review

The kit was easy to install and installation direction instructions were stamped on the gasket itself. Seems to be working great. I have the feeling that the car is a bit more of a pickup. (I also installed a cold air kit) I didn't notice any improvement in fuel consumption.

Product fits perfectly, installation took about 30 minutes. Quite difficult to find a place to install the throttle body but after that it was easy just by removing the inlet pipe from the hole haha. But a great product has a little more gas mileage as a result, I can drive 50 miles more than before on one tank of gas. and I travel a lot! I also like that whistling sound.

I purchased this gasket and cold air intake last Friday (4/24/15) and installed it on my 2009 Scion tC and then filled my tank. My old MPG was 23-25 and now after these mods I'm right at 30mpg. I'm expecting it to get a little better with more power (about 15%) and a complete change in sound just because of the hot rodding I did over the weekend. No more bumblebee noise when I step on the accelerator, just a LOW growl.

Purchased for my 2007 Scion. Apparently there are 4 screws and washers included. I have a screw and washer! The company won't do anything for me except return it and wait for a new one instead of just sending me 3 screws and washers. I could have paid half for a cheaper price, but I wanted to spend my money on American production. So much for that! BY THE WAY. I just saw they sent me a used one too. He cut all the dirt in the carvings into his design. Nice!