🔋 Amarine Made 12V Scavenge Impeller Pump - Diesel Fuel & Oil Transfer - White Shell Review

Good pump for used crankcase oil. I push it through a filter and feed it to a waste oil burner to heat it up. Translations are fast and not too loud. A good product.

waste oil suction from barrel. The pump has been running for 28 minutes. Then the thermostat burned out. the pump has stopped working. Disassembled, removed the melted Chinese switch and it works fine. Hundreds of gallons later.

Was an excellent fuel engine. A little stronger than I need but I got used to it. I really liked the transfer speed, but it was short-lived. He died a few months later. I have used this pump to transfer fuel from a reserve tank in my truck to a regular fuel tank. I do not recommend using this type of fuel.

The pump came with a broken cable grommet, had to be disassembled to repair. Also, the fittings that come with it are junk, I replaced them with real NPT fittings and got a much better fit. The suction power was so good that my suction hose broke. I used it to change the oil in boat engines. It probably wasn't any faster than my old plastic Sterns pump, but it's all metal and should last a long time.

This pump is serviceable. The threads on the pump body or on the barb fittings are very sloppy. I used both teflon tape and gas oil thread sealant to finally stop the leak and get good suction. I wanted to send it back but had to use it. Pretty loud but not overly so. It pumped engine oil at a rate of 2 gallons per minute. I measured it twice so I could estimate half a gallon over time since I don't have a meter for that. It looks well built. When pumping 15x40 engine oil at 65-70 degrees, it…